Fabrication and characterization of lead sulfide (PbS) thin film based heterostructure (FTO/CdS/PbS/Ag) solar cell by nebulizer spray method

S. Rex Rosario, I. Kulandaisamy, A. M.S. Arulanantham, K. Deva Arun Kumar, S. Valanarasu, Mohd Shkir, A. Kathalingam, S. Alfaify

Research output: Contribution to journalArticlepeer-review

21 Scopus citations

Abstract

This work deals with the study on the key properties of PbS thin films prepared by simple nebulizer spray method. The structural study done by XRD exhibited cubic crystal structure with polycrystalline nature for the deposited PbS films. The obtained crystallite size was varied between 41 to 55 nm for various molar concentrations. The morphology study done by SEM displays uniform distribution of the grains all over the surface of the prepared PbS thin films. The observed band gap value was decreased from 1.8 eV to 1.51 eV for various molar concentrations. The emitted PL intensity was strong at about 580 nm which is related to the near band edge (NBE) emission. Electrical studies performed by Hall Effect measurement confirm the p-type conductivity of prepared films. Resistivity and carrier concentrations are 2.92 ×103 Ωcm and 4.83 ×1013cm-3 respectively for the deposited films. In addition, a heterojunction solar cell of structure FTO/n-CdS/p-PbS/Ag was produced and its conversion efficiency was ∼0.39%. The nebulizer spray technique is very useful and novel method for the preparation of device quality PbS thin film.

Original languageEnglish
Article number056416
JournalMaterials Research Express
Volume6
Issue number5
DOIs
StatePublished - 2019

Keywords

  • Heterojunction device
  • PbS
  • Photoluminescence
  • SEM

Fingerprint

Dive into the research topics of 'Fabrication and characterization of lead sulfide (PbS) thin film based heterostructure (FTO/CdS/PbS/Ag) solar cell by nebulizer spray method'. Together they form a unique fingerprint.

Cite this